Klarstein Curve Mode D'emploi page 27

EN
Following their sequence shown
as picture assemble worm shaft,
lead cover, sausage canister
into cutting meat canister then
assemble cutting screw bar into
cutting meat canister clockwise.
Following their sequence shown
as picture, assemble worm shaft,
conductor, meatball canister into
cutting meat canister then
assemble cutting screw bar into
cutting meat canister clockwise.
Note: Please remember to di-
sassemble cutting cylinder from
the machine, when changing
these accessories.
Align arrow on cutting cylinder
to the other one on arm then
assemble prepared cutting
meat canister into arm
counter-clockwise shown as
picture. Fasten cutting screw bar
after cutting meat canister fixed
correctly.
27