Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
THE
DISHWASHER
WORK ?
1- Verify main water supply inlet is
correctly connected, open and free
from any obstructions.
2- Verify
main
electrical
working without any electrical break in
connections.
3- Verify the door is properly closed.
DISHWASHER DOES NOT WASH
WELL ?
1- Verify if the filters are cleaned, if not,
clean them. (see par. 3D4)
2- Verify if the washing water jets on the
washing arms are not obstructed by
any solid residues.
3- Verify correct amount and quality of
detergent and rinse aid. (see par.
3B2/3C2)
4- Verify if the dishes are correctly
loaded on the dishwasher. (see par.
3B6/3C7)
5- Washing cycle is too short. Use
another cycle (if available) or repeat
the washing cycle.
THE DISHES ARE NOT RINSED
WELL?
1- Verify if the rinse water jets on the
washing arms are not obstructed by
any solid residues.
2- Verify solenoid valve filter is free from
any obstructions such as lime or scale.
3- The inlet water pressure is inferior of 2
bar – 200 kPA. Install an external
pressure
device
to
increase the inlet water pressure
inside the machine.
THE DISHES ARE NOT DRIED WELL ?
1- Ask the rinse aid supplier to verify the
instruction for the rinse aid dosing.
(see par. 2D)
2- Verify if the rinse aid container is
empty. If yes, fill it with rinse aid
product. (see par. 2D)
3- Verify the quality and the quantity of
the rinse aid used and check with the
supplier. (see par. 2D)
4
– TROUBLESHOOTING
DOES
NOT
4- Verify the rinsing temperature is
supply
is
1- Verify if the rinse aid container is
2- Verify the quality and the quantity of
3- Remove the glasses rack immediately
1- Use only non foaming products for
1- Verify washing water temperature is
2- Ask the assistance service to verify the
3- Ensure the tank has not been cleaned
4- If foaming detergent has been used,
SMEARS OR SPOTS ON THE GLASSES ?
1- Ask
ensure
and
IN
EXTINGUISHER MUST BE USED.
IN CASE OF DANGER CUT-OFF THE
ELECTRICAL SUPPLY IMMEDIATLY.
The Manufacturer reserves the right to
modify the data presented in this
publication without notice.
between 80°C (176°F) to 90°C (194°F)
degrees.
CONDENSATION ON GLASSES ?
empty. If yes, fill it with rinse aid
product. (see par. 2D)
the rinse aid used and check with the
supplier. (see par. 2D)
after the end of each cycle.
STAINS ON GLASSES ?
professional dishwashers.
EXCESSIVE FOAM IN THE TANK ?
not less than 50°C (122°F) degrees.
instruction for the rinse aid dosing.
(see par. 2D)
with unsuitable cleaners. Drain the
tank and rinse throughly before new
wash cycles.
drain and refill the tank with water
until the foam disappears.
the
supplier
to
instruction for the rinse aid dosing.
EMERGENCY
CASE
OF
FIRE
A
verify
the
POWDER
15
Publicité
Chapitres
Table des Matières
