Warning Messages Displayed On The Control Panel - Jet-tech EV18 Mode D'emploi

3D3 – FILTERS CLEANNING
1- Turn OFF the machine by pressing button
"A" On/Off.
2- Manually remove the overflow and the
filters. (Fig.25)
Fig.25
3- Wash and clean filters thoroughly with
running fresh water.
4- Repositionated all filters and components
inside the machine.
3D4 – EXTERNAL SURFACES CLEANNING
Before carrying out any cleanning operations,
turn off the power at the mains.
To reduce the emmission of pollutants into
the enviroment, clean
(externally and where necessary internally)
with products having a biodegradability of
over 90%.
WARNING!
CLEAN STAINLESS STEEL SURFACES BY
USING WARM SOAPY WATER; NEVER USE
DETERGENT CONTAINING
SUBSTANCES NOR
COMMON WIRE WOOL, OR BRUSHES;
RINSE THOROUGHLY USING A WET CLOTH
AND CAREFULLY WIPE DRY. DO NOT
WASH THE APPLIANCE BY USING HIGH
PRESSURE WATER JETS.
3D5 – TURNING OFF THE MACHINE
1- Completely drain the water from the tank.
(see par.3D1/2/3)
2- Turn OFF the machine by pressing button
"A" On/Off.
3- Close the door and turn off the power at
the mains.
the appliance
ABRASIVE
STEEL SCRAPERS,
3E – WARNING MESSAGES
DISPLAYED ON THE CONTROL
PANEL
N.B.
If the machine is in OFF mode, warning
messages will not be visualized on the
display. Turn ON the machine to visualize
type of error.
The following warning
visualized on the display:
ALR 1 - WATER FILL
Water fill not completed during the available
maximum time (10min).
Verify that water supply
connected, opened and free of obstructions.
Verify that solenoid valve filter is free of
possible obstructions and deposit.
Verify that water supply pressure is adequate
(par.1D – Technical Data).
Verify that machine's door is completely
closed and the overflow device is correctly
positioned inside the tank.
N.B.
If water fill timing expires or water level
signal is not respected, solenoid valve is
automatically interrupted.
solenoid valve press any button on the
control panel.
ALR 2 - DRAIN ANOMALY
Drainage not completed on the maximum
programmed timing
.
Verify that the overflow device is completely
removed and not obstructions are present in
the water drain line.
ACTIONS AFTER MACHINE ERROR:
Booster and tank heating elements are
interrupted, water load is deactivated, control
panel display visualizes the error and the
electronic card is inactivated. All LED buttons
are OFF. Washing cycle is interupted (stanby
mode) and restored if the problem is solved. It
is always possible to turn OFF the machine by
pressing button "A" ON/OFF, and if the
problem is solved, warning messages are no
longer displayed.
messages are
is correctly
To restart
14