Haier HWE15XCR Guide D'utilisation Et D'entretien page 15

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

PREPARING THE AIR CONDITIONER cont.
1. Measure the width of the window opening. (See Fig.9)
2. Mark the center line on the inside of the windowsill with a pencil. (See Fig.10)
WIDTH OF
WINDOW OPENING
Fig. 9
WIDTH
NOTES AND WARNINGS:
• Be sure your air conditioner does not fall out of the opening during installation or removal.
• A grounded electrical outlet must be within 6 ft. (183 cm) of where the power supply cord
exits the air conditioner.
• Do not block the air discharge or air intake areas on the front panel.
• Do not block the louvers on the outside of the air conditioner.
INSTALL THE CABINET IN THE WINDOW
1. Center the cabinet in the window . Make sure to place the unit so that it is resting on the window
sill with a 1⁄4" to 1⁄2" downward tilt towards the outside. Lower the window sash behind the front
flange of the top channel to hold the unit in place. The bottom channel must rest behind the
window sill. (See Fig.11)
NOTE: The appearance of your model may differ from the one shown.
Top Channel
Fig. 11
WIDTH
(See Fig.11)
Lower Window Sash
HOW TO INSTALL
CENTER LINE
Fig. 10
HEIGHT
WIDTH
CENTER
PAGE 13

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Hwe18vcrHwe24vcrHwr15xcrHwr18vcrHwr24vcr

Table des Matières