Husqvarna TE 310 2010 Guide D'utilisation Et D'entretien page 155

- Pump with brake lever (3) or brake pedal (3A) in order to
push brake fluid out of line.
- Close the bleeding valve and fill the reservoir with fresh
brake fluid.
- Open the bleeding valve, apply the brake using the brake
lever or pedal, close the bleeding valve with the brake lever
or pedal applied and then quickly release the lever or pedal.
- Repeat this operation until the brake line is filled and clear
fluid starts coming out of the plastic hose: now close the
bleeding valve.
- Restore the brake fluid level (A) or (B) then reassemble the
rubber and the fluid reservoir cap (page 58).
After the brake fluid replacement, it is necessary to operate
the braking system bleeding (see pages 60 and 63).
TE-TC-TXC
SMR
61