Xxc0812 Side Mounting - Spinlock XX Clutch XX0812 Mode D'emploi

XX0812 Side Mounting
XXA0812 and XXB0812 Side Mounting
XX0812/HS

XXC0812 Side Mounting

XXC0812/HP and /HS are supplied Handed ready
for side mounting with 5 x Titanium Fastners, Nuts
Washers and Mounting Pad. See Diagram 1.
Remove the jaw set (Page 25) and fasten to the
deck using 5 x M6 Titnanium Fastners (Supplied).
Ensure 'pads' are in place so that XXC remaiin
horizontal to the deck and avoid flexing the body.
Apply 'Duralac' between the M6 fasteners and
the XXC body. Insert jaw set and close rear block.
(Page 25)
Align Rope Entry and Exit Moulding for
smoooth running and minimal friction.
XXC0812/HBP & HBS are designed for bonding
directly onto decks, spars and booms.
Note: we are unable to provide engineering data on
materials and instructions for bonding. It is essential
you refer to your own engineering design data,
load data and materials supplier for guidance.
If Side Mounting 2 XXC0812/HBP and S in a
'Butterfly' Back to Back (See Diagram 2) it is
essential to use XX-SMNT to ensure future removal
of XXC0812 Moulded Parts is possible.
34
www.spinlock.co.uk
XX0812/HP and XX0812/HS are supplied
'handed' ready for side mounting.
Remove the jaw set (page 25) and fasten to
the deck using 5 x M6 A4-70 stainless steel
fasteners (supplied). Insert jaw set and close rear
block. (Page 25.)
Align rope with entry and exit mouldings for
smooth running and minimum friction.
1
2
Custom options - contact: spt@spinlock.co.uk
ZS Alloy
• Custom colours to match hull, deck or spar.
• Handles printed with line application.
• Remote release system.
ZS Carbon
• Custom colours to match hull, deck or spar.
• Handles printed with line application.
• Available specifically for bonding.
• Remote release system.
• Jaw surfaces matched to specific rope types.
ZS Open
• Handle engraved with line application.
• Deck and rig mounting options available.
XX0812 and XXB0812
• Available in black, white and silver finishes.
• Handles engraved with line application.
• For weight saving on XX clutches contact the Special Projects team.
35