Battery Packs - Nilfisk Advance Backuum Battery Mode D'emploi

CHARGER
• This machine is equipped with a fully automatic charger.
• After the battery packs have discharged from use they can
be connected to the charger. The charger will automatically
begin charging when the proper temperature,
32 °F to 104 °F (0 °C to 40 °C), is reached.
• The LEDs on the charger will blink rapidly when the
batteries are ready for use (95% charged) and blink slowly
when the batteries are completely charged (100%).
• When the battery packs are fully charged the charger will
automatically switch into trickle charge mode and will not
overcharge the batteries.
• Charger should be located in an area with adequate
ventilation.
CHARGER LED STATUS TABLE
Charge mode
ON/stand-by
Rapid charge
Trickle charge
End of charge
Battery over/under
temp.
Error

BATTERY PACKS

• The machine is equipped with low voltage sensor and a high
temperature sensor. The number of charge and discharge
cycles of the batteries are maximized by means of these
sensors . The machine will not operate if the battery packs
are too hot or if a low voltage condition exists.
• Battery packs should be used and charged together as a
set. Do not mix battery packs if using more than 2 sets of
battery packs. It is a good idea to mark the sets.
• After the battery packs have discharged from use they can
be connected to the charger. The charger will automatically
begin charging when the proper temperature,
32 °F to 104 °F (0 °C to 40 °C), is reached.
• To obtain full run time from the battery packs after charging
the temperature must cool to approximately 104 °F (40 °C).
This typically takes 0,5 hour at room temperature.
• If the battery packs are connected before they are cooled
down, run time will be reduced due to the temperature
sensor within the machine.
• Be careful during use to avoid catching the battery
cables on objects and damaging the battery cable.
• This vacuum cleaner uses NiMH batteries.
HOW TO REPLACE BATTERIES
The NiMH batteries are placed inside the battery cases.
Never remove the battery from the case. Always replace
and order the batteries together with the battery case.
Each battery has a terminal that is connected by a pin plug.
The method of replacing batteries is to first disconnect the
wires connecting the batteries to the cleaner. This is done
by twisting and then pulling the clamping circuit until the
wires from the cleaner are separated from the wires to the
batteries. Then remove the battery case from belt. This is
done by lifting up the flap and pushing the button on the
backside of the battery case so that the case is separated
from the belt. Refit new batteries in reverse order. The used
batteries should be placed in a sealed plastic bag and then
handled according to all locally approved precautions and
environmental regulations. Always order a complete battery
pack set - battery and battery case, when replacing batteries.
Red LED Green LED
ON ON
ON
—
Blink rapidly
—
Blink slowly
—
ON
—
Blink rapidly
—
• Used batteries should be disposed of safely and placed in a
sealed plastic bag and then handled according to all locally
approved precautions and environmental regulations.
• Warning! Never use non rechargeable batteries in this
vacuum cleaner.
• If the batteries are leaking, return batteries to a disposal
plant or a similar local facility. Any leakage from the batteries
can be removed with household paper. Leaking batteries
and fouled household paper should be placed in a sealed
plastic bag and then handled according to all locally approved
precautions and environmental regulations. If leakage from
the batteries has been in contact with skin, eyes or clothes
- remove battery leakage with water.
• The batteries must be removed from the appliance before the
appliance is scrapped.
• The charger must be disconnected from the supply mains
when removing the battery.
• The battery is to be disposed of safely and in accordance
with all locally approved precautions and environmental
regulations.
The symbol on the product or on its packing indicates
that this product may not be treated as household waste.
Instead it shall be handed over to the applicable collection
point for the recycling of electrical and electronic equipment.
By ensuring this product is disposed of correctly, you will
help prevent potential negative consequences for the
environment and human health, which could otherwise be
caused by inappropriate waste handling of this product. For
more detailed information about recycling of this product,
please contact your local city offi ce, your household waste
disposal service or the shop where you purchased the
product.
9