Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Standby (Hors Gel) Mode
It is the mode enabling to maintain a temperature of approximately 7°C in the room in case of pro-
longed absence from the house.
a) Leave switch
on the Marche position.
b) Set the knob
to
Turbo mode
It is the mode enabling to set the device into Forced Operation, ensuring prompt temperature
increase in the room over the time defined (maximum power for conventional models and fan acti-
vation point for models with ventilating fan).
a) Leave the switch
b) Select the time for the Turbo using the knob
c) Press the command
d) The TURBO mode can be interrupted manually before the end of the time set. In order to do
this, press the command
NB: For piloted devices, only the heating stop and frost setting instructions are prioritised when
TURBO mode is activated (the other instructions are inoperative).
Locking commands
It is possible to lock the knob
dren...).
1
Locking the knob:
a) Set the knob to the position required.
b) Using a small-size flat-blade screwdriver, pull the knob's cap (1).
c) Detach pin P from its stand using a cutting tool.
d) Set pin P in the alignment of arrow B (2).
e) Refit the cap.
Limitation of the knob's use range:
a) Using a small-size flat-blade screwdriver, pull the knob's cap (1).
b) Remove the two P pins from their stand using a cutting tool.
c) Position the two P pins at each end of the operating range desired (3).
d) Refit the cap.
.
on the Marche position.
, the indicators
and
again.
or restrict its use, preventing untimely handling of the device (chil-
2
P
.
light.
3
B
L
21
P
GB
Publicité
Chapitres
Table des Matières
