Construction Characteristics - Ferroli AQUA1 PLUS 200 IT Manuel D'installation Et Maintenance

Installation and maintenance manual
3

CONSTRUCTION CHARACTERISTICS

1 Heat pump
2 Control panel.
3 Enclosure in embossed ABS.
4 Electric heating element
5 Replaceable magnesium anode.
6 Air inlet ( 160 mm).
7 Air outlet (
8 Cold water inlet connection joint (G 1").
9 Hot water outlet connection joint (G 1").
10 Recirculation fitting (G ¾").
11 Condensate drain (G 1/2").
12 Inlet, coil fitting for solar thermal power system (G 1"
13 Outlet, coil fitting for solar thermal power system (G 1"
14 Steel tank (boiler) enamelled according to UNI standards (capacity: 200; 260 litres).
15 Condenser.
16 Hermetically-sealed rotary compressor.
17 High-efficiency finned evaporator with Al-tube without welding
18 Ambient air recirculation fan.
19 Upper boiler probe.
20 Lower boiler probe.
21 50 mm polyurethane insulation.
160 mm).
; 1 m exchange surface).
1/4 2
; 1 m surface).
1/4 2
pag. 4 / 23