Thermador COOK'N'VENT UCV30 Instructions D'utilisation page 3

Figure 1
Top Cap
Filters
Snorkel
Blower Assembly
J-Box
Support Leg
Wing Nuts
INTRODUCTION
GENERAL DESCRIPTION
®
The complete Universal Cook'n'Vent
System consists of the ventilator intake and a blower. See Fig. 1. The blower is either an integral
(mounted on the vent intake in the cabinet under the cooktop) or a remote (roof or outside wall mounted).
When a remote blower is used, a duct transition is mounted on the ventilator intake in place of the integral
blower to connect the intake to the ductwork. The duct transition must be purchased separately. (see Table
1 . )
The integral blower or duct transition can be mounted in different positions on the intake to route ductwork
to avoid cabinet, building framing, utilities, etc. Important: To allow for cleaning access, locate blower
in the position closest to the duct outlet.
The Universal Cook'n'Vent® System is available in 30-inch, 36-inch and 45-inch models, with countertop
trim in either stainless, black, or white. It is intended for use with any residential 30-inch, 36-inch or 45-inch
model (Thermador or other) gas or electric cooktop. It is not intended to be used with any professional
style cooktop or range.
Page 2