KIRAMI Comfort Cozy Mode D'emploi page 35

35/75
Notice also the fire safety in front of the furnace. There shouldn't be any combustible materials
in front of the furnace. There should be an area, which is demonstrated in the picture that
should be made of incombustible material such as concrete, sand or metal.
Grates
For the TUBE heater, two cast iron grates and one L-shaped iron plate
will be delivered. Those are to be positioned on the tracks in the heater.
The order of the grates is shown on the right side. L-shaped iron plate
is to be installed bended edge upwards. It will deflect the air and also
prevent the firewood to drop out from the heater.
Chimney
You can use a Ø150mm outer diameter acid-proof chimney with
this heater. The reduced end of the chimney fits inside the heater.
The chimney parts can be purchased separately in three different
lengths: 25 cm, 50 cm and 100 cm. There are also available
adjustable chimney corners and 100 cm long protective sleeves
for the lower part of the chimney.
We recommend a chimney kit for the heater. This package
includes 200 cm chimney + 100cm protective sleeve and a
standard hat. There are also spark protective hats available for the chimney.
If you have purchased a chimney kit with the heater. It is supplied in a separate box and has
four parts (see picture right) and it has to be assembled.
Remove the protective film from the thermal protection and place the assembled chimney to
the chimney outlet of the stove.
Be careful, the edges of the chimney are very sharp. Use protective gloves!
Magnesium anode rod
Magnesium will work as anode, meaning that magnesium will corrode
before heater's aluminium does.
The mangesium rod should be replaced annually or after it has been
depleted. If the rod hasn't been changed on time the heater won't have
guarantee left.
Replacement instructions are on the replacement rod package.
NB! Before heating up check that the thread is waterproof. If water is leaking through the
thread then fasten it more and check that o-ring is in place.