KIRAMI Comfort Cozy Mode D'emploi page 27

27/75
Chimney
Be careful, the edges of the chimney are very sharp. Use protective gloves!
The chimney is delivered in a separate box and it consists of four parts
(picture on right) and it needs to be assembled. Remove the protective film
from the thermal protection and place the assembled chimney to the
chimney outlet of the stove.
Grates
The CUBE stove has two grates and one solid L-shaped iron. They are installed on
the stove brackets as indicated in the picture. The L-shaped iron should be the first
edge turned upwards. This way, it works as a spoiler and it also keeps the firewood
in better. These should always be in place when using the stove. (image on right)
MACU stoves come with a cradle fireplace grate where a single wire tray grate is
installed. An air iron plate is placed on the top shelf to direct the circulation of air in
the upper part of the firebox. It is prohibited to use the stove without these parts.
Note that these parts wear down over time and get bent and their form will change
in use. You can purchase new ones as spare parts when needed (image on the right).
The first use
The water circulation of the stove shall be rinsed by letting plenty of water in from the pipe above,
so that any metal chips from grinding come out. Collect any trash by swiping it off the bottom of the
tub. When you fill the tub, check the fastening pipes of the stove for any leakages.
USE
When filling the tub, note the number of people because people entering the tub will displace the
water when they enter the tub. If there will be many people in the tub, leave the water surface at
the minimum.
In case you are using your own pump for filling the tub, remove the pumping hose after you have
filled the tub. Many pumps do not have a return valve to prevent the water discharge from the tub
when the pumps are switched off. Before filling the tub, check that the bottom plug of the tub is
closed, ensure that the plug is in place after you have some 10 cm of water in the tub.
Minimum fill:
The tub needs to be filled at least 5 cm above the upper
connection pipes of the stove before lighting the fire in the stove
(picture on right).
Do not let a full tub freeze in the winter. Empty the tub or ensure
appropriate heating.
Do not connect the stove to the circulation pump; it cannot ensure
the pressure because it is planned only for gravitational