Samsung NZ30K7880U Série Mode D'emploi page 33

Problem Possible cause
The surface unit The element will cycle on
frequently cycles and off to maintain the
on and off. power setting.
Scratches or The cooktop is being cleaned
abrasions on the improperly.
cooktop surface.
Cookware with rough
bottoms was used on the
cooktop or there were
coarse particles (eg. salt or
sand) present between the
cookware and the surface of
the cooktop.
Cookware has been slid
across the cooktop surface.
NZ30K7880U_DG68-00823A-06_EN+MES+CFR.indb 33
Solution
This is normal operation, and Brown streaks or
not a system failure. Cycling specks.
at the high power setting is
normal and can occur if the
cookware is too small for the
cooktop element or if the
cookware bottom is not flat.
Use the cooktop as usual.
Scratches are not removable.
Tiny scratches will become
less visible in time as a result Areas of
of cleaning. Use ceramic glass discoloration
top cleaning cream. Do not with metallic
use chemical or corrosive sheen.
agents. These agents may
damage the surface of the
product.
To avoid scratches, follow
the recommended cleaning "Cracking" or
procedures. Make sure "popping" sound.
cookware bottoms are clean
before use, and use cookware
with smooth bottoms.
Problem Possible cause
Boilovers have been cooked
onto the surface.
Mineral deposits from water
and food have been left on
the surface of the cooktop.
This is the sound of the
metal heating and cooling
during cooking.
Solution
• Wait until the surface
cools down. Then, use a
single-edge razor-blade
scraper at approximately
a 45° angle against the
glass surface to remove
the soil.
• See the section on the
care and cleaning of the
glass cooktop on page 30.
• Remove using a ceramic-
glass cooktop cleaning
cream.
• Use cookware with clean,
dry bottoms. Clean the
cooktop with a ceramic
cleaning agent regularly
every week.
This is normal operation and
not a system failure. Use the
cooktop as usual.
English 33
2018-08-29 2:28:00