Makita DHR263 Manuel D'instructions page 6

ENGLISH
(Original instructions)
1 Red indicator
2 Button
3 Battery cartridge
4 Star marking
5 Battery indicator
6 Switch trigger
7 Lamp
8 Reversing switch lever
9 Quick change chuck for SDS-
plus
10 Change cover line
11 Change cover
12 Spindle
SPECIFICATIONS
Capacities
No load speed (min
Blows per minute
Overall length
Rated voltage
• Due to our continuing program of research and
development, the specifications herein are subject to
change without notice.
• Specifications and battery cartridge may differ from
country to country.
• Weight, with battery cartridge, according to EPTA-
Procedure 01/2003
Intended use
The tool is intended for hammer drilling and drilling in
brick, concrete and stone as well as for chiselling work.
It is also suitable for drilling without impact in wood,
metal, ceramic and plastic.
General Power Tool Safety Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future
reference.
CORDLESS ROTARY HAMMER SAFETY
WARNINGS
1. Wear ear protectors. Exposure to noise can cause
hearing loss.
6
Explanation of general view
13 Quick change drill chuck
14 Rotation with hammering
15 Rotation only
16 Hammering only
17 Grip base
18 Teeth
19 Loosen
20 Tighten
21 Side grip
22 Protrusion
23 Bit shank
24 Bit grease
25 Bit
Model
Concrete
Steel
Wood
–1
)
Net weight
DHR263
350 mm
4.6 kg
2. Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
3. Hold power tools by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring. Cutting
accessory contacting a "live" wire may make
exposed metal parts of the power tool "live" and
could give the operator an electric shock.
ENE043-1
4. Wear a hard hat (safety helmet), safety glasses
and/or face shield. Ordinary eye or sun glasses
are NOT safety glasses. It is also highly
recommended that you wear a dust mask and
thickly padded gloves.
5. Be sure the bit is secured in place before
operation.
GEA010-1
6. Under normal operation, the tool is designed to
produce vibration. The screws can come loose
easily, causing a breakdown or accident. Check
tightness of screws carefully before operation.
7. In cold weather or when the tool has not been
used for a long time, let the tool warm up for a
while by operating it under no load. This will
loosen up the lubrication. Without proper warm-
up, hammering operation is difficult.
8. Always be sure you have a firm footing.
GEB046-2
Be sure no one is below when using the tool in
high locations.
9. Hold the tool firmly with both hands.
10. Keep hands away from moving parts.
11. Do not leave the tool running. Operate the tool
only when hand-held.
26 Chuck cover
27 O symbol
28 Action mode changing knob
29 Depth gauge
30 Dust cup
31 Blow-out bulb
32 Chuck adapter
33 Drill chuck
34 Sleeve
35 Ring
36 Limit mark
37 Brush holdre cap
38 Screwdriver
DHR264
26 mm
13 mm
32 mm
0 – 1,250
0 – 5,000
374 mm
4.7 kg
D.C. 36 V