Pl An The Ins Tal Lati On - Bosch HDDREC5UC Guide D'installation

PART S S UPPL IED
1 - Recirculation Box
1 - Recirculation Filter
1 - Decorative Grille
1 - Parts Bag (containing):
6 - #10 x .625" screws
4 - #8 x .375" screws
2 - #8 x 1" screws
4
PL AN THE
INS TAL LATI ON
IMPORTANT - Installation Requirements
The DHG602DUC 600 CFM Flexible Blower can be
installed in either of two ways:
(1) As an integral blower attached directly to the
downdraft and stabilized with mounting legs.
(2) As an inline blower, not attached directly to the
downdraft, using mounting brackets and wood
framing.
Please see installation manual for more details.
Purchase blower separately. (Includes mounting legs
and mounting brackets.)
A minimum 24-inch wide cabinet is recommended. For
left / right exhaust through cabinet toe kick, a 30" deep
cabinet is recommended to align properly with flex
blower.
The 8-inch round blower outlet and 8-inch round
recirculation box inlet must align vertically. (See page 5.)
1. Determine where recirculation box will exhaust through
cabinet.
• Front (toe space), Back, Side (Left or Right).
• 14 1/2" (368) x 15" (380) opening in cabinet base is
required for recirculation box.
• 3 1/2" (89) x 14 1/4" (362) opening is required for
exhaust.
2. Determine location of recirculation box.
• Plan to align blower outlet with recirculation box inlet.
3. Determine what lengths of duct are required. (Purchase
duct separately.)
• A length of 8" (203) round duct is required to connect
blower exhaust to recirculation box inlet.
• A length of 3 1/4" (83) X 14" (356) duct may be required
to connect to exhaust of recirculation box and extend to
decorative grille location.
OPENING IN
CABINET BASE
3 1/2" (89) X 14 1/4" (362)
EXHAUST OPENING
DECORATIVE
GRILLE
EXHAUST THROUGH CABINET FRONT (TOE KICK)
FILTER
RECIRCULATION
BOX
14 1/2"
(368)
15"
(380)
Measurements in inches (mm).