Fan Run-On Time; Lighting; Saturation Display; Audible Signal - Bosch DWB121K50 Notice D'utilisation

Fan run-on time

Switching on
Note: If an intensive mode is activated, fan run-on is not
available.
Select the fan level.
1.
Press the + button.
2.
The fan continues to run at this set fan level for 10 minutes
and then switches off automatically once this time has
elapsed. If the lighting is switched on, it remains on once the
run-on time has elapsed.
Switching off
Press the button.
#
The fan run-on ends before the remaining run-on time has
elapsed.

Lighting

The lighting can be switched on and off independently of the
ventilation system.
Switching on or off
Press the button.
B
Setting the brightness
Press and hold the button until the desired brightness is
B
reached.

Saturation display

When the metal grease filters or the activated charcoal filter
are/is saturated, a signal sounds for approx. four seconds after
the fan is switched off.
The bar above the corresponding button flashes:
Metal grease filter: E
■
Activated charcoal filter:
■
If you have not yet done so, carry out the following steps now:
Clean the metal grease filters or replace the activated
■
charcoal filters; see section Cleaning and maintenance or the
"CleanAir air recirculation module" printed supplement.
Reset the saturation indicator; see section Cleaning and
■
maintenance.
Resetting the saturation displays
Press the E button.
1.
The saturation indicator for the metal grease filter no longer
flashes and is reset.
Press the F button.
2.
The saturation indicator for the activated charcoal filter no
longer flashes and is reset.

Cleaning and maintenance

:
Risk of burns!
The appliance will become hot during operation, especially
near the bulbs. Allow the appliance to cool down before
cleaning.
:
Risk of electric shock!
Penetrating moisture may result in an electric shock. Clean the
appliance using a damp cloth only. Before cleaning, pull out the
mains plug or switch off the circuit breaker in the fuse box.
F
Switching over the display for circulating-air mode
Starter set for circulating-air mode
For air recirculation, the electronic control display must be
switched over accordingly:
Check whether the extractor hood is connected and switched
1.
off.
Press and hold the and
#
2.
the bars above button 1 and
The electronic control is switched over to air recirculation.
CleanAir recirculation module
For air recirculation, the electronic control display must be
switched over accordingly:
Check whether the extractor hood is connected and switched
1.
off.
Press and hold the # and
2.
the bars above button 1 and
Press and hold the and
#
3.
the bars above button 2 and
The electronic control is switched over to air recirculation.
Switching over the display for exhaust air mode
Check whether the extractor hood is connected and switched
1.
off.
Press and hold the and
#
2.
the bar above the button lights up.
E
The electronic control is switched back to air extraction.

Audible signal

Switching on
Switch off the fan.
1.
Press and hold the and
#
2.
three seconds.
An audible signal sounds. The audible signal is switched on.
Switching off
Switch off the fan.
1.
Press and hold the # and
2.
three seconds.
An audible signal sounds. The audible signal is switched off.
:
Risk of electric shock!
Do not use any high-pressure cleaners or steam cleaners,
which can result in an electric shock.
:
Risk of injury!
Components inside the appliance may have sharp edges. Wear
protective gloves.
buttons at the same time until
+
light up.
F
+ buttons at the same time until
F light up.
buttons at the same time until
+
light up.
F
buttons at the same time until
+
buttons for approx.
C
C buttons for approx.
15