Connection; Installation; Break In; Installing On A Flat Surface - Martin Logan MOTION FX Guide De L'utilisateur

C
onneCtion
WARNING! Turn your amplifier
off before making or breaking any
signal connections!
These speakers are designed with easy-to-use
push-style binding posts that accept bare wire or
pins (fig. 2). Additionally, by removing the rubber
inserts, they will accept banana plugs (fig. 3)
Assign the same color to the (+) and (–) terminals
on both the speaker and the amplifier. Make certain
that all connections are tight.
Fig. 2
i
nstallation
WARNING! Installation other
than that described in the body of
this document requires specific
documentation from MartinLogan.

BREAK IN

Allow approximately 72 hours of break-in at 90
dB (moderate levels) before any critical listening.

INSTALLING ON A FLAT SURFACE

If you have a surface that provides a wide, level,
and stable platform, the speaker can be placed
directly on top. When using the speaker in this
configuration, affix two pads to the bottom of the
speaker (fig. 4). Note: This speaker is not magneti-
4
Fig. 1
Fig. 3
Fig. 4