Epson EMP-8300 Guide De Mise En Route page 26

Item
WEP
Ad-hoc Mode
Explanation
Select "Enabled" and enter a cipher key for ciphering
data to be sent. If the cipher key has been registered
using WEP, data communication is allowed between
devices with the same cipher key only.
Enter a cipher key consisting of 5 or 13 ASCII
characters or 10 or 26 hexadecimal characters.
(No key ID is required because only one WEP key
can be defined.)
Select "Enabled" to start direct communication with
a PC via the wireless LAN (but without passing
through an access point).
Set this option to "Enabled" if you wish to select
"Easy connect mode" from the Network Screen.
"Projecting PC Images (Network Screen)" in the
EasyMP.net Operation Guide
25