Electrical Connections - krispol STARCUS K06 Notice D'utilisation

All electrical connections must be made after the power supply is cut off and with any potential emergency battery disconnected.
IMPORTANT! Before starting any work on the control panel
(connection, maintenance), always cut off the power supply.
To connect an external control, safety and signalling device, use openings provided for this purpose (sealed with gaskets) in the control
unit housing.
Install the electrical connections according to the diagram shown in the figure below.
1
Pulse switch
TX RX
+ OUT
- + -
GND
FLASH
After installation, make sure that electrical wires do not touch the moving parts of the garage door.
Check the status of inputs and make sure that all safety devices are properly connected.
Program the drive using the control panel (see sec. 7):
Wiring diagram of the control board
2
Photocells
GND NO
PB
COM
NC NO
NC/NO
STOP
2 PB
3 PE
GND
+24V DC
4 FLASH
3 4
Lamp Reed switch / STOP
NC
5 DOOR

6.5. Electrical connections

5
Emergency battery
STOP
230V AC
NC
L N PE
MAX
5OOW
24V/2.4Ah
6 BAT
+
-
COM
NO
NC
33
EN