Check Installation - GE IM-5D Manuel D'utilisation Et D'installation

INSTALLING ICEMAKER
PLUG IN THE ICEMAKER
5
• Place icemaker and fill cup on top of lower
basket contents, or ice bucket (for support),
with the wire and connectors facing up .
Install the six pin connector first and then
the four pin connector .
4-Pin Connector
MOUNT THE ICEMAKER
6
• Lift the icemaker up and rotate to align the
slots on the side of the icemaker with the
mounting pins
in the freezer
wall . Slide the
icemaker back
so the fill tube
on the top
wall fits inside
the fill cup
opening .
• Make sure:
- The connector plugs are still firmly in the
sockets .
- The fill tube extends into the fill cup
opening at the back of the icemaker .
- The icemaker is level .
• Check the wiring to make sure the ice maker
is plugged in correctly .
10
Installation Instructions
(cont . )
6-Pin Connector
4-Pin Connector
6-Pin Connector
Screw
Hole
Fill Tube
Mounting Pins
Mounting Screw

CHECK INSTALLATION

7
• Push the icemaker back toward the rear
of the cabinet so the mounting screw
hole in the icemaker flange aligns with
the mounting hole in the freezer side wall,
making sure wires are not hanging outside
of wire housing .
• Install self-tapping
hex head screw
from the kit into
the hole in the
flange of the
icemaker .
REMOVE THE ICE BUCKET
8
• Remove the ice bucket from the basket .
• For non-counter depth modles: Install the ice
bucket cover onto the ice bucket by snapping
pins into holes at the back of the ice bucket .
Fill Cup
NOTE: Kit comes with two ice buckets . Counter
depth models will use smaller bucket . Use extra
bucket (in models with "Y" in model number
such as GYE) for additional ice storage or it can
be recycled .
Hex Head
Mounting Screw
Ice Bucket
Cover
Ice Bucket
(Front)