Troubleshooting; Disposal - Hilti WSR 1000 Mode D'emploi

power tool free from oil and grease. Do not use
cleaning agents which contain silicone.
8.3 Maintenance
WARNING
en
Repairs to the electrical section of the power tool
may be carried out only by trained electrical spe-
cialists.

9. Troubleshooting

Fault
The power tool doesn't start.
The power tool doesn't
achieve full power.
The saw blade can't be re-
moved from the blade holder.

10. Disposal

Most of the materials from which Hilti power tools or appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, Hilti has already made
arrangements for taking back your old power tools or appliances for recycling. Please ask your Hilti customer
service department or Hilti representative for further information.
10
Printed: 07.07.2013 | Doc-Nr: PUB / 5071339 / 000 / 00
Check all external parts of the power tool for damage
at regular intervals and check that all controls operate
faultlessly. Do not operate the power tool if parts
are damaged or when the controls do not function
faultlessly. If necessary, the power tool should be
repaired by Hilti Service.
8.4 Checking the power tool after care and
After carrying out care and maintenance work on
the power tool, check that all protective and safety
devices are fitted and that they function faultlessly.
Possible cause
Interruption in the electric supply.
The supply cord or plug is defec-
tive.
The control switch is defective.
The extension cord is too long or
its gauge is inadequate.
The control switch is not pressed
fully.
The locking sleeve is not turned as
far as it will go.
maintenance
Remedy
Plug in another electric appliance
and check whether it works.
Have it checked by a trained electri-
cal specialist and replaced if neces-
sary.
Have it checked by a trained electri-
cal specialist and replaced if neces-
sary.
Use an extension cord of an ap-
proved length and / or of adequate
gauge.
Press the control switch as far as it
will go.
Turn the locking sleeve as far as it
will go and remove the saw blade.