Very Important - BaByliss PRO FLASH Mode D'emploi

ENGLISH
FX668E
CORD/CORDLESS
PROFESSIONAL CLIPPER
Please keep these instructions for
future reference.
OPERATING INSTRUCTIONS
Remove the plastic head guard
protecting the blades.
Apply oil across the blades; wipe off
any excess with a dry cloth.
Charge
Before using your clipper for the
first time, allow it to charge in
its base for 16 hours. And then
subsequent charges should be 2
hours. Make sure beforehand that
the clipper is turned off before
allowing to charge.
Plug one end of the power cable
into the charging base and the
other end into an outlet. Make sure
the charging indicator light is on.
It lets you know that the clipper is
charging properly.
The clipper can be kept in its
charging base without damaging
the battery.
To optimize the battery's life,
recharge the clipper regularly
before the battery is completely
empty.
• At charging: Red LED blinking,
full charge green LED continue on
• At discharging: LED off until
battery low voltage remind red
LED turn on
• With cord used: green LED
continue lighted.
Use with cord
The clipper can be used with the
power cord. For this, you need only
plug the cord into the clipper and
then into the outlet. Then push the
operating switch into position I.
When finished cutting hair, remove
trimmings from the blades using
the cleaning brush.
Wipe the housing clean with a dry
cloth. Before replacing head guard,
apply a few drops of lubricating oil
to the blades to prevent any rust
from occurring.
This quality haircutting instrument
has been manufactured with
e x tre m e c are. It has b e e n
thoroughly tested and inspected
before reaching the professional
user.
As with all precision instruments,
there may be a period of breaking
in. If the speed of the motor varies
(as indicated by a change in sound
or pitch), it is an indication of a
change in position of the clipper
or a fluctuation in line voltage.
When the clipper is lubricated
in accordance with instructions,
it will deliver ample power and
speed for professional hair cutting
requirements.
VERY IMPORTANT: Blades must
be cleaned and oiled on a regular
basis for proper functioning.
Failure to clean and oil the
blades regularly will void the
warranty.
8