BaByliss PRO FLASH Mode D'emploi page 10

HOW TO USE COMB
ATTACHMENTS
To use the comb attachments, turn
the clipper to the OFF position.
Slide the comb attachment onto
the top of the clipper blades, and
then pull down and over the back
of the blade set (Fig. 2).
To remove, pull up on the back of
the comb attachment and then pull
away from the blades.
(Fig. 2)
ADJUSTABLE TAPER LEVER
The taper lever is positioned at your
thumb. You can hold the clipper in
your hand and adjust the lever
at the same time – while you are
clipping.
The taper lever adjusts the
closeness of the cut from a close
cut with the taper lever in the UP
position, to a longer-length cut
with the taper lever in the DOWN
position.
To increase cutting length, slowly
push the lever down.
To cut closer, push the lever up.
Because a different cutting edge
is used in each setting, using the
taper lever lengthens the life of
your blades.
Packed-in hair can slow down any
clipper. To remove hair without
removing the blades, keep the
clipper on and quickly push the
taper lever back and forth from
"close" to "longer" cut several times.
If you do this every time, especially
after heavy hair cutting, the blades
should remain free of cut hair.
EUROPEAN AND UK IB
INSTRUCTION FOR NIMH
BATTERY
1. Charging the clipper
Before using the clipper for the
first time, charge continuously
for 16 hours. Maximum battery
capacity will only be reached after
3 charging/discharging cycles.
2. Preserving the batteries
In order to maintain the optimum
capacity of the rechargeable
batteries, the clipper should be
recharged for 16 hours every 3
months approximately.
3.Ni-MH Batteries Removal
This clipper has Nickel-Metal
Hydride batteries. In an effort to
protect the environment, these
batteries should be removed
and properly disposed of when
the unit is no longer operating.
To remove the battery block for
disposal or recovery, follow these
instructions:
10