Harman JBL Club A600 Mode D'emploi page 5

WIRING FOR AUDIO OUTPUT
One subwoofer ( 4ohm/2ohm )
+ -
Subwoofer
SUB
L R
Two subwoofers ( 4ohm )
+ -
Subwoofer
SUB
L R
CONNECTING THE REMOTE BASS
CONTROLLER
+ -
Subwoofer
REMOTE
CONTROL
SETTING GAIN, CROSSOVERS, AND BASS
BOOST
Setting the gain
1. Start with
and the crossover control rotated midway.
2. Choose music with substantial bass
content.
3. Turn the volume control on your receiver to
¾ of its total output.
4. Adjust the
listening carefully to the bass output. If
you hear distortion, turn the
counterclockwise to decrease the gain.
Selecting the crossover frequency
Choose the crossover point to suit listening
preferences. Turn the dials to the left to lower
the crossover point and to the right to raise
the crossover point. Exact crossover settings
depend on your listening preferences.
Selecting the subwoofer phase
Switch the
determine which setting provides the most
clean bass output.
Selecting the bass boost
Adjust the
counterclockwise to suit your taste.
SPECIFICATIONS
Club A600
Power output @ 4 ohms 350 watts RMS x 1 600 watts RMS x 1
Power output @ 2 ohms 600 watts RMS x 1
Frequency response 10-320 Hz
32-320 Hz variable,
Crossover frequencies
12 dB/octave
Line-level input 200 mV rms -
sensitivity 2.0 V rms
High-level input
2V rms - 20V rms.
sensitivity
Signal-to-noise ratio >80 dB
THD+N @ rated power <1%
Fuse rating 30 A x 2
Operating voltage 9~16 V
8-11/16" x 2-1/16"
Dimensions (W x H x D) x 7-1/8" (220 mm x
51.3 mm x 180 mm)
Weight 2.46 kg
Recommended wire
gauge
control set to minimum,
control clockwise,
control
back and forth to
control clockwise or
Club A1000
1000 watts RMS
x 1
10-320 Hz
32 -320 Hz variable
12 dB/Octave
200 mV rms -
2.0 V rms
2V rms - 20V rms.
>80 dB
<1%
35 A x 3
9~16 V
12-5/8" x 2-1/16" x
7-1/8" (320 mm x
51.3 mm x 180 mm)
3.52 kg
8 4
EN