Operation With Batteries - Sharp QT-CD180W Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operation with AC power
VOLTAGE SELECTOR
AC
AC
To AC INPUT
110-127V
220-240V
Check the setting of the AC voltage selector located on the bottom
before plugging the unit into an AC socket. If necessary, adjust the
selector to correspond to the AC power voltage used in your area.
Selector adjustment:
Slide the selector with a screwdriver to the appropriate voltage number.
(AC 110 - 127 V or AC 220 - 240 V)
AC plug adaptor:
In areas (or countries) where an AC socket as shown in illustration 2
is used, connect the unit using the AC plug adaptor supplied with the
unit, as illustrated. The AC plug adaptor is not included in areas where
the AC wall socket and AC power plug can be directly connected (see
illustration 1 ).
Notes:
If the unit will not be used for a long period of time, remove the AC
power lead from the AC socket.
Connection of the AC power lead to the unit disconnects the batter-
ies.
Never use a power lead other than the one supplied. It may cause an
electric shock or fire.
AC 110-127/
1
220-240 V,
50/60 Hz
2
To an AC socket

Operation with batteries

1
Disconnect the AC power lead, and remove the battery compart-
ment cover.
2
Insert 6 "D" size batteries (UM/SUM-1, R20, HP-2 or similar) into
the battery compartment.
Insert the batteries according to the direction indicated on the rear panel.
When inserting or removing the batteries 3 and 6 , push them toward
the ë battery terminals.
Installing the batteries incorrectly may cause the unit to malfunction.
3
Replace the battery compartment cover.
Battery replacement:
Replace the batteries when they become weak and/or recording or playback is
impaired. This may occur even though radio broadcasts are audible.
Remove the battery compartment cover, and insert your finger in the hole on
the bottom of the unit to remove batteries.
Notes:
Replace all old batteries with new ones at the same time.
Do not mix old and new batteries.
Remove the batteries if they are weak or if the unit will not be used for long
periods of time. This will prevent potential damage due to battery leakage.
Batteries are not included.
Caution:
Do not use rechargeable batteries (nickel-cadmium battery, etc.).
2
3
1
5
6
4

Publicité

Table des Matières
loading

Table des Matières