FAR DGV18CH Manuel D'utilisation page 63

respective holes in the flame spreader. The
flame spreader must lock properly in place.
2. Position the cover of the burner (1,2,3) on
the flame spreader (4) so that the holding
rods fit in their respective recesses.
Put the parts back in the correct order
after cleaning. Do not mix the top and
the bottom. The holding rods must be
inserted exactly in the notches.
Warnings
• Do not modify this appliance.
• This appliance must be installed by a certified
technician or installer.
• Before the installation, make sure that the
local supply conditions (nature and pressure of
the gas) and the settings of the appliance are
compatible.
• The settings for this appliance are listed on the
label (or rating plate).
• This appliance is not connected to a device
for evacuating the combustion products. It
must be installed and connected according to
the installation standards in force. Particular
ENGLISH
GB-17