FAR DGV18CH Manuel D'utilisation page 62

ENGLISH
• Soak in hot water and a little detergent or
washing-up liquid.
• After cleaning and washing them, wipe them
and dry them thoroughly. Make sure that
the holes for the flames are cleaned and dried
completely.
• Wipe the fixed parts and the cups of the
burners with a damp cloth, then dry them.
• Gently wipe the flame supervision device and
ignition device with a well wrung-out cloth
and then dry with a dry cloth.
• Before placing the burners on the hob, make
sure that the injector is not blocked.
• Reassemble the auxiliary and rapid burners
as follows:
1. Place the flame spreader (4) on the burner
cup (5) so that the ignition device and the
flame supervision device are aligned with their
GB-16
2
1
3
4
5
6
7
2
3
4
7
6
5