EMS AIRFLOW Prophylaxis Master Mode D'emploi page 74

Between each patient
Overall cleaning and disinfection
Clean Clean Clean the external Clean the external the external the external surface of
with a cloth and alcohol with a cloth and alcohol with a cloth and alcohol with a cloth and alcohol
Clean the unit only with an alcohol-based (ethanol,
isopropanol), colorless disinfectant.
Never use scouring powder or an abrasive sponge. It
will damage its surface.
End of day: Overnight cleaning
Use only EMS NIGHT CLEANER
Other products may damage or not clean the unit, and cause patient intoxication.
1
Place the Place Place Place the the NIGHT the NIGHT NIGHT NIGHT
® ® ® ®
CLEANER CLEANER bottle onto bottle onto
CLEANER CLEANER bottle onto bottle onto
the device the device the device the device
Before placing, remove
CLIP+CLEAN from the device.
Each cleaning consumes 30ml
®
of NIGHT CLEANER .
Before cleaning, check that
the liquid level is above the
external black line of the
bottle's neck.
The NIGHT CLEANER
6
Alternative long-term disinfection liquid, Alpro Bilpron, can be used.
ENGLISH
surface of the surface of surface of the device the the device device device
®6 as a cleaning agent.
2
Set water to 10 Set water Set water Set water to 10 to 10 to 10
Turn the Turn the Turn the Turn the device ON device ON device ON device ON
Set both water regulators
to 10 to ensure the flow of the
cleaning agent.
®
agent can remain active in the device's water lines for up to 1 week.
FB-618/EN – Rev. A-01 - 2017.03.30
Reprocess handpieces and instruments Reprocess handpieces and instruments Reprocess handpieces and instruments Reprocess handpieces and instruments
See the specific following chapters.
Risk of contamination. Always disinfect the bottom and
top areas of device air connections.
3
H H H H old old both old old both both both cords cords cords cords over a over a over a over a
sink sink with sink sink with with CLIP+CLEAN with CLIP+CLEAN CLIP+CLEAN CLIP+CLEAN
Contamination prevention:
Do not make any contact
between the sink and the
cords.
CLIP+CLEAN shall be
reprocessed after each use.
(Do not exceed 135°C).
4
Press the pedal once, Press the pedal once, Press the pedal once, Press the pedal once,
release, and then wait 1 1 1 1 release, and then wait release, and then wait release, and then wait
minute minute minute minute
The white and blue countdown
indicates remaining time.
Cleaning can be paused and
resumed by pressing the pedal
again.
Once completed, leave the
®
NIGHT CLEANER bottle on
the device overnight.
24/46