Abus CO2WM110 Manuel D'utilisation page 27

High humidity increases the CO
keep the detector away from areas where there are many people or objects that
could emit CO
To calibrate manually, place the detector outdoors and press the three buttons
approx. 16 minutes until the flashing stops. Calibration is completely automatic.
Cleaning
· Dusty detectors have to be cleaned.
Dust deposits in the air inlets of the detector can be vacuumed or blown out.
· If necessary, you can remove the dust with a brush.
· The surface can be cleaned using a cloth lightly moistened with soapy water.
· Do not allow water to enter the inside of the device!
· Do not clean the device in a dishwasher!
· Do not use sharp, pointed, abrasive, or corrosive cleaning materials or hard
brushes!
· Do not use chemicals and do not clean the detector with highly flammable liquids!
Kohlendioxidmelder_CO2WM110_Manual_1.indd 27 Kohlendioxidmelder_CO2WM110_Manual_1.indd 27
content in the air. When calibrating manually,
2
, such as ventilation pipes, chimneys or cars.
2
simultaneously. "CO2" will flash during calibration, which lasts
– 27 –
Cleaning
GB
19.02.2021 15:14:00 19.02.2021 15:14:00