LF Master Forge BG2294B-LS Mode D'emploi page 17

NATURAL GAS CONVERSION
WARNING:
Place the grill on a flat, level surface.
Before the conversion, make sure all control knobs are in the OFF position, LP tank valve is closed,
and tank is disconnected from regulator and removed from grill.
1. Turn off gas supply, and then remove cap on gas supply side.
2. Recommended: Install a shut-off valve on gas supply side before installing the socket.
3. Socket should be installed by an authorized technician in accordance with the national fuel
gas code (NFPA 54-2015/ANSI223.1-2015).
4. Before inserting plug, turn on gas supply and leak test all connections including the stem of
the shut-off valve and the opening of the socket. For best results, use an ammonia-free soap
and water solution.
Nominal Gas Consumption
Model NO.: BG2294B-LS
Gas Type
φ
Propane 0.92 x 5pc;
Natural Gas φ 1.3 x 5pc
OPERATING INSTRUCTION:
1. To connect, push back socket sleeve (Fig. 1).
2. Insert plug and release sleeve (Fig. 2).
3. Push plug until sleeve snaps forward (Fig. 3).(Gas
will flow automatically. Failure to connect plug
properly to socket will inhibit gas flow to the
appliance.)
4. Test connection with ammonia-free soap and water
solution.
To disconnect
1. Pull sleeve back. Pull plug out of socket. (Gas is
automatically shut off.)
2. Close shut-off valve and replace dust caps on
socket and plug.
IMPORTANT:
Sticking the NG Label on the bottom panel.
Conversion kits NO.: 5210327 (For natural gas conversion use)
Orifice size gas consumption
mm
Total gas
consumption
Btu/hr
10000 x 5
10000 x 5
17
Gas pressure
kPa
Btu/hr
50000 2.74
50000 1.74
Fig. 1
Fig. 2
Fig. 3