JVC DLA-RS65 Manuel D'instructions page 68

3
Adjustments and settings in the menu (continued)
See Pixel Adjust Flow and Operation: Adjust(Pixel)
Use this function to make general adjustments in the slight color errors in the horizontal/vertical directions of
the video images.
Select [Adjust Area] to [Whole] and select [Adjust Color] and [Adjust Pattern]. Move the cursor to
[Adjust(Pixel)], then press the [OK] Button on the remote control to display the adjust pattern and adjust
(pixel) window on the screen.
Adjust(pixel) window
You can use the [UP], [DOWN],
[LEFT], and [RIGHT] buttons to
change position.
Press the [OK] button on the remote control to enter the adjust operation mode. Use the [UP], [DOWN],
[LEFT], and [RIGHT] buttons to move and adjust pixels in the vertical and horizontal directions across the
entire screen. The adjustment settings appear in the center of the Adjust (pixel) window. Use the [BACK] but-
ton to exit the adjust operation mode.
Pixel adjust setting
Remote Control Operation Guide
Use the [GAMMA] button on the remote control to change [Adjust color].
Use the [PIC ADJ] button on the remote control to change [Adjust Area] and switch to the Zone adjust
screen. At the same time, the zone cursor will appear on the adjust pattern.
Use the [COLOR P.FILE] button on the remote control to change [Adjust pattern]. Use the [COLOR TEMP]
button on the remote control to change [Adjust (Pixel)] and [Fine Tune] and switch to the fine tune window.
(*) This becomes [Adjust (Pixel)] when the Adjust Area is set at "Zone".
You can use the [BACK] button on the remote control to stop pixel adjust. When in Adjust Operation Mode,
the [BACK] button will exit the mode.
68
Operation
Whole Adjust (Pixel)
ADJUST. Color P.
Color A.
COLOR.
GAMMA
TEMP
Whole Adjust (Pixel)
ADJUST.
Color A.
COLOR.
GAMMA
TEMP
Pixel Adjust
Red
H 1
V 1
Select
A. Area
BACK
COLOR. PIC.
BACK
Operate
P.FILE. ADJ.
H (Horizontal)
Adjust(pixel) window
Pixel Adjust
H 1
V 1
Color P. A. Area
PIC.
COLOR.
P.FILE. ADJ.
Adjust Pattern
Adjust Color
Red
Select
BACK
BACK
Operate