JVC DLA-RS65 Manuel D'instructions page 64

3
Adjustments and settings in the menu (continued)
[3] Installation
Use this function to set and adjust installation method and projection
environment.
Use the UP/DOWN keys to select an adjustment item. Press the [BACK]
key to return to the previous screen.
Items
Lens Control
Pixel Adjust
Installation Style
Front
Ceiling Mount (F)
Rear
Ceiling Mount (R)
Keystone
Horizontal
Vertical
Anamorphic
A
B
Off
Screen Adjust
Black Level
64
Operation
Explanation, operation, precautions, settings
To sub-menu "[3-1] Lens Control"
To sub-menu "[3-2] Pixel Adjust"
Matching the state of the projector's projection, one can switch horizontal and vertical flip /
forward switch.
Settings: Front, Ceiling Mount (Front), Rear, Ceiling Mount (RE)
Front upright projection mode.
Ceiling/front projection mode.
Rear upright projection mode.
Ceiling/ rear projection mode.
In regards to the projection plane, any occurring keystone distortion is adjusted in case
the installation location is inclined.
(*) There may be instances, when the video image - after having corrected keystone
distortion - will not match the screen. The position with a shift correction of 0% position is
an exception.
(*) When there is a 3D input signal, adjustment is not possible.
Adjusts the horizontal keystone.
Settings: -40 to 40
Adjusts the vertical keystone.
Settings: -30 to 30
The video images are projected after being enlarged in the vertical direction of the panel
resolution. This setting is used when one uses the anamorphic lens to enlarge them in the
horizontal direction.
If a 3D signal is fed in when Anamorphic mode is set to A or B, Anamorphic mode is
automatically turned Off.
Settings: A, B, Off
Video with an aspect ratio of 2.35:1 is enlarged in the vertical direction of the panel
resolution and then projected.
Video with an aspect ratio of 16:9 are displayed by reducing them in the horizontal
direction, without changing their size in the vertical direction.
Used when watching video images other than those with a 2.35:1 aspect ratio while using
an anamorphic lens. 2.35:1 video images are projected without any changes. (Black
bands appear on all sides)
It corrects the white balance fault according to the reflective properties of the projection
screen. Please adjust to your preference.
Sets the black level when used indoors.
Settings: 0 to 10
The frame is displayed in the center as shown in the figure on the right. (Resolution is
emphasized in this figure and is not a true representation.) The actual black that can be
displayed by this machine is shown in the right frame. Adjust so that the borderline shared
with the left frame does not stand out.
(*) This adjustment decreases shading, making fine adjustments from the black (dark) side
to the white (bright) side. Adjust settings according to your preference.
Lens Control
Pixel Adjust
Installation Style
Front
Keystone
Anamorphic Off
Screen Adjust
Black Level
[Front]
[Off]
[0]
[0]
[0]