General Information - Agilent Technologies Turbo-V 903 Notice De Mode D'emploi

General Information

This equipment is destined for use by professionals. The user should read this
instruction manual and any other additional information supplied by Agilent
before operating the equipment. Agilent will not be held responsible for any
events occurring due to non-compliance, even partial, with these instructions,
improper use by untrained persons, non-authorized interference with the
equipment or any action contrary to that provided for by specific national
standards.
The TV 903 Pumping System is an integrated system with a turbo-molecular
pump for high and ultra-high vacuum applications with its relevant controller.
The system can pumps any type of gas or gas compound. It is not suitable for
pumping liquids or solid particles.
The pumping action is obtained through a high speed turbine (max. 48000
rpm) driven by a high-performance 3-phase electric motor. The TV 903
Pumping System is free of contaminating agents and, therefore, is suitable for
applications requiring a "clean" vacuum.
It is equipped with auxiliary connectors to supply an additional fan, to be
controlled from a remote site by means of an host computer connected through
a serial line (RS232 or RS485).
The following paragraphs contain all the information necessary to guarantee
the safety of the operator when using the equipment. Detailed information is
supplied in the appendix "Technical Information".
This manual uses the following standard protocol:
The caution messages are displayed before procedures which, if not followed,
CAUTION!
could cause damage to the equipment.
Turbo-V 903 Pumping System User Manual / 87-901-016-01
Instructions for Use

General Information

(A)
17
247/306