Troubleshooting; Maintenance / Cleaning - LIVARNO LUX HG00394A Instructions De Montage

Now reattach the cover
Make sure the cover
(see Fig. F). Secure clockwise using the three
screws .
9
Then reattach the housing
clockwise using the two screws
Reattach the solar module
tube or .
2 3
Slide the On / Off switch
again.
Screw the sphere
module , turning clockwise.
5

Troubleshooting

Note: The product contains sensitive electronic
components. Radio transmitting equipment in the
immediate vicinity may therefore cause interference.
These could be e.g. mobile phones, two-way radios,
CB radios, radio / other remote controls and micro-
waves. If you notice the product is malfunctioning,
remove any sources of interference from the area
around the product.
Notice: Electrostatic discharge can lead to mal-
functions. In the event of such malfunctions, briefly
remove and reinsert the rechargeable batteries.
12 GB/IE/NI
to the solar cell
10
is in correct position
10
and secure
8
.
7
to the spacer
5
to the ON position
6
all the way into the solar
4
Note: The performance of the rechargeable
.
12
battery is better in summer than in winter due to
the weather.
Error Cause
LED Surroundings
doesn't are too bright
light up or light from
other light
sources is hit-
ting the prod-
uct
Weak Rechargeable
LED light battery not
fully charged
or defective
LED LED defective
doesn't
light up

Maintenance / Cleaning

Note: The LED cannot be replaced. The product
is maintenance-free.
Never use caustic cleaners.
Solution
Change the location
(away from e.g. yard
or street lighting)
Charge the re-
chargeable battery
with a charger or
replace with a new
rechargeable battery
(see "Replacing the
battery")
The LED cannot be
replaced. Dispose of
the product properly
(see "Disposal")