Water Line Installation Instructions - LG LSXC22486 Série Manuel Du Propriétaire

Water Line Installation Instructions

WARNING
Electrical Shock Hazard:
When using any electrical device (such as a
power drill) during installation, be sure the
device is battery powered, double insulated
or grounded in a manner that will prevent the
hazard of electric shock.
Install the shut off valve on the nearest.
frequently used drinking water line.
1
SHUT OFF THE MAIN WATER SUPPLY
Turn on the nearest faucet to relieve the
pressure on the line.
2
CHOOSE THE VALVE LOCATION
Choose a location
for the valve that is
easily accessible. It is
best to connect into
the side of a vertical
water pipe. When it is
necessary to connect
into a horizontal water pipe, make the
connection to the top or side, rather
than at the bottom, to avoid drawing
off any sediment from the ater pipe.
3
DRILL THE HOLE FOR THE VALVE
Drill a ¼ in. hole in
the water pipe using
a sharp bit. Remove
any burrs resulting
from drilling the
hole in the pipe. Be
careful not to allow
water to drain into
the drill. Failure to drill a ¼ in. hole may
result in reduced ice production or smaller
cubes.
NOTE
The hookup line cannot be white, plastic
tubing. Licensed plumbers must use only
copper tubing (NDA tubing #49595 or
#49599) or Cross Link Polyethylene (PEX)
tubing.
4
FASTEN THE SHUTOFF VALVE
pipe with the pipe clamp.
5
TIGHTEN THE PIPE CLAMP
Pipe Clamp
S a d d l e - Ty p e
NOTE
Commonwealth of Massachusetts Plumbing
Codes 248CMR shall be adhered to. Saddle
valves are illegal and their use is not permitted
in Massachusetts. Consult with a licensed
plumber.
Tighten the clamp screws until the sealing
washer begins to swell.
NOTE: Do not overtighten clamp or
you may crush the tubing.
6
ROUTE THE TUBING
Pipe Clamp
Clamp Screw
Route the tubing between the cold water
line and the refrigerator.
Route the tubing through a hole drilled in
adjacent base cabinet) as close to the wall as
possible.
NOTE
8 feet (2,4 m) coiled into 3 turns of about 10 in.
(0,25 m) diameter) to allow the refrigerator to
move out from the wall after installation.
INSTALLATION 17
Vertical Cold
Water Pipe
Washer
Inlet End