BH FITNESS LK500UiB Manuel Du Propriétaire page 9

STEP 1
ASSEMBLY OF THE FRONT STABILIZER
Assemble Main Frame (A) and Front Stabilizer
(C) and attach them with Truss Hex Screw (K04)
& Spring Washer (K02).
STEP 2
ASSEMBLY OF THE REAR STABILIZER
Assemble the Rear Stabilizer (D) and Main Frame (A), then attach with truss Hex Screw
(K04) & Spring Washer (K02).
16
STEP 3
SEAT PAD AND PEDAL ASSEMBLY
Take off the screw nut and washer on Seat Pad (N) and set aside. Attach the Seat Pad (N)
onto the Seat Set (O) with the screws, nuts, and washer, that were set aside, and tighten
securely. Slide the Seat Set (O) into the Seat Tube (F), install and tighten the CKS Screw (K-
11). Adjust the seat forward or back and secure with the knob under the back of the Seat Set.
Then, pull the POP PIN out and put the Seat Tube (F) into the Main Frame (A) (follow the
arrow as seen in figure below). Once the seat is at the desired height, tighten the handle on
the POP PIN to secure the Seat Tube (F). Finally assemble the Left and Right Pedals (J,I).
The pedlas are marked with an "L" for Left and "R" for Right. Make sure to attach the pedals
on the correct side.
Note: Pedals are labeled left and right, please place them on the appropriate side.
LK500UiB v3
17
LK500UiB v3