BH FITNESS LK500UiB Manuel Du Propriétaire page 10

STEP 4
CONTROL TUBE ASSEMBLY
Put Control Tube Decorative Cover (H) onto Control Tube (E) (as shown in 4-1) and thread
the main frame's lower control wires through the control tube. Then attach the Control Tube
(E) to the Main Frame (A) with Truss Hex Screw (K01), Spring Washer (K02), Flat Washer
(K03) (attach following arrows as show in figure below). After securing the Control Tube (E)
slide the Decorative Cover (H) down to cover the bolts.
18
STEP 5
CONSOLE/CONTROL TUBE SET/ HANDRAIL TUBE ASSEMBLE
Attach the Handrail Tube (B) to the Control Tube (E) and tighten with Truss Hex Screw
(K09) and Spring Washer (K10). Then connect the lower/upper control wires with the
lower/upper hand grip pulse wires and upper and lower control wires. tuck the wires into
the Control Tube (E). Attach the Console (G) to the Control Tube (E) with Truss Philips
Screw (K05). Finally, attach the Waterbottle holder (L) on Control Tube and tighten
with Truss Philips Screw (K06), then put Waterbottle (K) into the holder.
LK500UiB v3
19
LK500UiB v3