Intended Use; Assembly And Operation - Worx Sonicrafter WX677 Mode D'emploi

SYMBOLS
To reduce the risk of injury,
user must read instruction
manual
Warning
Wear ear protection
Wear eye protection
Wear dust mask
Do not dispose of batteries.
10
Return exhausted batteries to
your local collection or
recycling point.
Do not expose to rain or water
Do not burn
Avoid danger of injury from the
sharp edges of the accessories.
Accessories can become very
hot while working, presenting
danger of burns!
Make sure the battery is
removed prior to changing
accessories.
Oscillating Tool
Wear protective gloves
High oscillation frequency.
Low oscillation frequency.
LED light is a battery capacity
=
indicator and will flash when
- - -
- - -
power gets low .
OPERATION INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.

INTENDED USE

The power tool is intended for sawing and
remodeling wooden materials, plastic,
plaster, non-ferrous metals and fasteners (e.g.
nails and clamps) as well as for working on
soft wall tiles and for dry grinding of small
surfaces. It is especially suitable for working
close to edges and for flush cutting.

ASSEMBLY AND OPERATION

Action
Mounting Accessories
Mounting The Sanding
Sheet
Mounting The Suction
Device (not supplied)
Operating The On/Off
Switch
Using The Variable
Speed Dial
Remove Or Install
Battery Pack
LED Light
Figure
See Fig. A1,A2,A3, B
See Fig. C
See Fig. D1-D5
See Fig. E
See Fig. F
See Fig. G
See Fig. H
EN