Ayce EHP-18O Manuel D'utilisation page 37

Figure 1a
1. Drill holes in the wall by following the steps in Figure 1. Make sure they are all
correct.
Ø10mm
560mm
Figure 1b
2. Place all the Rawl plug in the holes in the wall, as in the previous step
3. Attach the upper brackets using screws
4. Place the radiator on the brackets
5. Attach the lower brackets with screws and place the radiator to the wall
1 wall 3
2 Rawl plug 4
hook 5 heater
screw
Warning: Before plugging in the unit make sure
the radiator is properly attached to the wall.
Otherwise problems can occur.
DESCRIPTION
1 / The Control Panel
I
- Power switch
- On / off
+ - Hold both buttons for 3 Seconds to lock or unlock control panel
- Setting time, day and temperature
- Mode selection and programs
- Increase of the selected criterion
- Decrease of the selected criterion
- Pilot mode (Only for France)
2 / LCD display
3 / Operating instructions
The radiator has three different operating Modes.
72 | 73
1 - Hour
2 - Day
3 - Program number
4 - Select program
5 - Timer
6 - Comfort mode
7 - Economic mode
8 - Frost mode
9 - Time scale
10 - Program content
11 - Locking radiator
12 - Heating on
13 - Stand by mode
14 - Programmed temperature
GB