Zanussi ZDT16002 Notice D'utilisation page 22

Using the detergent
Caution! Use only detergents for dishwashers.
Do not use more than the correct quantity of deter-
gent. Refer to the instructions on the detergent
packaging.
1
A
3
Put the detergent or the
tablet in compartment (A A ).
B
If the programme has a
prewash phase, put a
small quantity of detergent
in compartment (B B ).
Detergent tablets do not fully dissolve with short
programmes and detergent residues can stay on the
dishes.
We recommend that you use detergent tablets with long
programmes.
22
2
A
4
S S etting and starting a programme
Setting mode
The appliance must be in setting mode to accept some
operations.
The appliance is in setting mode when, after the activa-
tion:
• The display shows 2 horizontal status bars.
• The indicators of the programme buttons come on.
If the control panel shows other conditions, press and
hold function buttons (B B ) and (C C ) at the same time until
the appliance is in setting mode.
Starting a programme without delay start
1. Open the water tap.
2. Press the on/off button to activate the appliance.
3. Make sure that the appliance is in setting mode.
4. Set the programme. The related programme number
flashes in the display.
5. Close the appliance door. The programme starts.
• If you open the door, the display shows the pro-
gramme duration that decreases with steps of 1
minute.
Starting a programme with delay start
1. Set the programme.
2. Press the delay button again and again until the dis-
play shows the delay time you want to set (from 1 to
19 hours).
• The delay time flashes in the display.
• The delay indicator is on.
3. Close the appliance door. The countdown starts.
• If you open the door, the display shows the count-
down of the delay start that decreases with steps of
1 hours.
• When the countdown is completed, the programme
starts.
Opening the door while the appliance operates
If you open the door, the appliance stops. When you close
the door, the appliance continues from the point of inter-
ruption.
Cancelling the delay start
Press and hold function buttons (B B ) and (C C ) at the same
time until:
• The delay indicator goes off.