4. SYSTEM lNSTALLATlON
An authorized technician must be in charge of installing the equipment according to individual state
regulations.
Follow the indications in the figures carefully.
Step 1
Step 1.- Drill a hole in the
surface of the sink with a
19 mm diameter bit.
Step 4
Step 4.- Remove the inlet
valve from the sink faucet.
Step 7
S t e p
7 . -
M o u n t
equipment's exhaust outlet.
Step 2
J o in t
Step 2.- Pass the faucet
trough the hole.
Step 5
Step 5.- nstall the inlet switch
valve of the equipment on the
exit side of the valve for the sink
water faucet.
Step 8
Step 8.- Attach the water intake
t h e
of the equipment to the inlet
switch valve installed in Step5.
Step 3
J oint
Washer
Nuts
Racor
for tube
c o n n e c t io n
Step 3.- Mount the faucet with
the components indicated in
the figure and in the same
order.
Step 6
Step 6.- Drill a hole in the sinks
exhaust pipe with a 7,2 mm
diameter drill bit.
Step 9
Step 9.- Connect the
exhaust of the equipment
to the sinks exhaust.
6