Osmosis OSMOSOR 5E Mode D'emploi page 18

2. UNPACKlNG AND CONTENTS VERlFlCATlON
Remove the equipment from its packaging and verify that it contains the following items.
Before any use check the box and components to make sure they have not been damaged during
its transportation.
Any claim resulting from damages during handling must be accompanied by the transport
company's name and the transporter must be informed within a maximum of 24 hours after
having received the merchandize.
Description
Osmoser 5 stages
osmosis membrane, properly protected
Dispensing valve with ceramic closure
Entry valve
nstallation kit with connections
White 1/4 PE tube
Remove plastic bags as they can be dangerous for children.
3. lNSTALLATlON SUGGESTlONS
Besides the installation notes the following indications should be considered
-Choose an appropriate place for the system placement, on a flat surface and protected from direct solar
radiation, rain or humidity. n its proximity there should be a water supply, a drain output and an electric
connection.
- t is recommended to install an entry valve at the system water inlet in order to make maintenance easier.
- The system must not be started if it has not been previously connected to the water supply network.
- The system is designed to operate with water temperatures between 10°C and 40°C.Do not install the
system using a hot water input.
- The system must be placed as shown in the pictures. n no case should it be placed on its side.
- t is recommended to install a pressure regulator at the water inlet in case of a variable pressure or a
pressure above 6 bars.
- A osmoser 5 stages system with pump should be installed when inlet water pressure is below 3 bars.
- When the entry valve is closed, do not forget to switch off the osmoser. This will prevent the valve from
overheating.
Quantity
1 un.
1 un
1 un
1 un
1 un
5 meters
5