BabyGo Car Seat Manuel D'utilisation page 18

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
ADJUST THE HEIGHT OF HARNESSES
Crotch belt adjustment
According to the size of baby body, crotch belt have two position you can choose to use of this
car seat, method: angle of the seat raised to maximum, pull up the seat cover, slide and remove
the visible locking clip from crotch belt of child restraint sitting part, re for to a new suitable po-
sition, buckle up locking clip with tip of belt.
Removal of car seat cover
1. To remove the child restraint cover, please do the same operation as described in D.4 (Chan-
ging the height of harnesses).
2. Release the crotch harness, slide it through the strap slot in the cover. Remove the cover.
Wash instructions
1. The cover may only be washed by hands in the temperature below 300 C, using soft deter-
gents, do not bleach, do not whirl and do not dry in drier.
2. A part of the car seat is made of plastic and it can be cleaned using slightly warm water with
soap. Do not use aggressive cleaning agents.
3. The belts should be cleaned with a damp cloth. Do not use any solvents or bleaches that
could damage the webbing and make the belt unsafe.
Upper material
Padding
18
18
There are 3 harness positions available, you can select according to child's
height. For group 0+, weight from newborn to 13kg, you should use the lowest
positions. For group 1, the mounting height of the harnesses should be adjus-
ted to the child's height, so that child's shoulder would be at the same leave as
the harness coming out from the back.
1. Remove the locking clip from the tip of the harness located on the right side
under the child restraint.
2. Thread the ending of the belt through the lower opening on the side of the
sitting part.
3. Remove the buckle tongue from the belt.
4. Pull the ending of the belt through the right shoulder strap slot in the back-
rest, and through the adjustment strap located on the back of the backrest,
thread it through the left shoulder strap slot in the backrest.
5. To restore the previous position of the harness, repeat above operation in
reverse order.
100 Polyester
100 Polyester
Car Seat

Publicité

Table des Matières
loading

Produits Connexes pour BabyGo Car Seat

Table des Matières