BabyGo Car Seat Manuel D'utilisation page 15

ROUTING OF THE SEAT BELT
1. For group 0+(less than 13kg) use, put the child restraint in a rear-facing position and use the
base support on the seat of car.
Warning!: To ensure child's back is evenly supported, do not put more
than one nappy on the child and make sure the nappy is not likely folded
at the back.
2. For group (9 – 18kg)use, place the car seat in forward facing position on the seat of the car.
TWO KINDS OF INSTALLATION METHODS FOR CHILD SAFETY SEAT
1. Group 0+, rear-facing installation (Suitable child's weight from newborn to 13kg ), please
make sure to use rear-facing position (Fig ), the seat must be located at the maximum tilt
angle (3 stalls)and use base support.And make sure to use red clip.
Note: Extreme danger. Do not use a rear facing child restraint in passenger
seats equipped with airbag! Do not use in forward facing position when
child's weight under 9kg.
2. Group forward facing installation (Suitable child's weight between 9 to 18 kg), please make
sure to use forward facing position (Fig ). And make sure to use red clip. Install child safety car
seats with three-point seat belts
Rear-facing position
Car Seat
15
15