BabyGo Car Seat Manuel D'utilisation page 16

Forward-facing position
16
1. According to child's weight, place the child seat on the vehicle seat you can
choose rear facing (Fig or forward facing (Fig ).To the best cling of car seat
backrest abilities, achieve the desired effect by the angle of the cat seats
when you need.
Important:
the red clip
2.
to transferred out bottom of the child restraint base, and place the child seat
on the vehicle seat, with the back of child seat facing the road. Pull the ve-
hicle seatbelt to the longest and thread the car seatbelt through child seat
between restraint sitting part and restraint base. (shown Fig ), then insert
iron plates in the seat belt buckle. One seat belt stuck to groove of the Child
restraint sitting part, another seat belt stuck to groove of the child restraint
base. Last, fasten the seatbelt and pull it tight.
Important:
the red clip
3. Bandage method for forward facing: place the car seat in forward facing po-
ped forward,. Pull the vehicle seatbelt to the longest and lateral pull the car
seatbelt to the space between child restraint sitting part and child restraint
base. (see Fig ) Assured one vehicle seatbelt horizontal cross the groove of
the child restraint base. Then insert iron plates in the seat belt buckle, fas-
ten the seatbelt and pull it tight. Last, insert one vehicle seatbelt of backrest
through the red clip and close it tightly.
Note: Be sure to check the seatbelts are not folding and enlace. On the road, all
you adjust the seat angle, please pull the vehicle seatbelts tight again and close
them tightly to use red clip.
Car Seat
-