Controls And Settings; Direct Controls - Urmet 3000/328 Manuel De L'utilisateur

2

CONTROLS AND SETTINGS

2.1

DIRECT CONTROLS

POWER CONNECTOR
Connect the supplied power cavle to the mains connector.
ON/OFF BUTTON [G]
This is used to switch the monitor on and off. The blue LED lights up when the monitor is on while when it is in red stands
for standby condition.
IMPORTANT NOTE
If the following message appears on the monitor after pressing the button (G):

NO SIGNAL
It means that a not connected video signal has been selected as input. To select it, use [A] button.
SELECTION AND DIMENSIONS BUTTONS [B-C]
They allow to select the menu options inside the OSD Menu or to change the size of the image
VARIATIONS AND VOLUME BUTTONS [D-E] AND CONFIRM [E]
They allow to change the parameters the volume (E button increases the volume – D button decreases the volume)
without entering the menu. E button also allows to confirm each setting.
MENU BUTTON [F] AND CONFIRM
This is used to access and quit the OSD (On-Screen Display) Menu and to confirm the selected settings
VIDEO INPUT SELECTION BUTTON [A]
To select the desired signal (""VGA", "HDMI1", "HDMI2, DP or "BNC") press the button (A) and select the desired item
with the buttons (B-C) "DOWN" and "UP". Press the button "E" to confirm.
HDMI1 – HDMI2 SIGNAL INPUT
It allows the connection of an HDMI signal and an audio signal, coming from an external source provided with an HDMI
output
VGA SIGNAL INPUT
VGA input.
AUDIO INPUT
Audio input on Jack connector
BNC INPUT/OUTPUT SIGNAL
BNC input e BNC output LOOP-THROUGH.
DP SIGNAL INPUT
DP Input
DS3000-003 12