Yamaha FJR1300AP 2008 Supplément Au Manuel page 20

Coupler (for siren controller)
Coupler (for microphone)
Coupler (front flashing light)
Headlight beam adjusting cable
Clamp
Wire harness
Right handlebar switch lead
Identification red tape
Route the wire harness at the back of the headlight beam adjusting cable.
Route the wire harness along the bottom of the square pipe frame and clamp it at the
white tape. Direct the clamp end downward.
Route the wire harness just at the head.
To the turn signal light and horn
To the main battery, including the siren, etc.
Connect the headlight lead and wire harness. (Connect the couplers of the identical color.)
Fix the headlight cord and wire harness to the headlight mounting stay with the clamp.
Leave the clamp end to lie on the inside of the cowling.
Route the clamp through the hole in the stay and fix the wire harness at the white
tape. Cut off the clamp end.
Route the wire harness under the stay.
To the extension wire lead under the fuel tank
To the handlebar switch lead and siren
Clamp the wire harness at the white tape together with the headlight lead. Direct the
clamp end downward.
-14-
MAINTENANCE