Initial Preheating; How To Set: Water Hardness - AEG BSE792280M Notice D'utilisation

BEFORE FIRST USE

5.3 Initial preheating

Preheat the empty oven before the first use.
Step 1 Remove all accessories and removable shelf supports from the oven.
Step 2
Set the maximum temperature for the function:
Let the oven operate for 1 h.
Step 3
Set the maximum temperature for the function:
Let the oven operate for 15 min.
The oven can emit an odour and smoke during preheating. Make sure that the room is ventila‐
ted.

5.4 How to set: Water hardness

When you connect the oven to the mains you have to set the water hardness level.
Use the test paper supplied with the steam set.
Step 1
Put the test paper
into water for about
1 sec. Do not put
the test paper under
running water.
The colours of the test paper continue to change. Do not check water hardness later than 1
min after test.
You can change the water hardness level in the menu: Settings / Setup / Water hardness.
The table shows water hardness range (dH) with the corresponding level of Calcium deposit
and the water classification. Adjust the water hardness level according to the table.
64/260
Step 2
Shake the test paper
to remove the excess
of water.
.
.
Step 3
After 1 min, check
water hardness with
the table below.
Step 4
Set the water hardness
level: Menu / Settings /
Setup / Water hard‐
ness.