Insert Battery - LaserLiner MoistureMaster Compact Manuel D'utilisation

Read the operating instructions and the enclosed brochure "Guarantee
!
and additional notices" completely. Follow the instructions they contain.
This document must be kept in a safe place and passed on together
with the device.
Function / application
This material moisture measuring device operates in accordance with the
capacitive measuring principle. Material moisture is measured by 2 conductive
sensor pads on the underside of the device and calculated in % with internal
material-dependent characteristics. MoistureMaster is used to determine the
moisture content in wood, cement screed CT-C30-F4 DIN EN 13813, anhydrite
screed CAF-C25-F5, aerated concrete DIN4165 PP2-0.35/0.09, plaster as per
DIN EN 13279-1 / plaster thickness = 10 mm, concrete C20/25 and lime-sand
brick 12-1.8 in a non-destructive manner.
The integrated building materials characteristics correspond to the
specified building materials and their designation. Building materials of
the same type but with different designation / composition / strength /
density can however affect the measurement result. Furthermore,
building materials will vary from manufacturer to manufacturer due
!
to the way they are produced. This is why, in the event of different
product compositions or unfamiliar construction materials, a one-off
comparative moisture measurement should be taken using methods
that can be calibrated (e.g. kiln-drying method). If different measured
values occur, they should either be viewed relatively or the index
mode for moisture/drying behaviour should be used.
1

Insert battery

Open the battery compartment on
the housing's rear side and insert
a 9V battery (6LR61 9V). Correct
polarity must be observed.
MoistureMaster Compact
2.
1.
3.
13
EN