Cleaning And Care - Backyard Grill GBC1870W-C Manuel D'utilisation

19
W CAUTION:
1. All cleaning and maintenance should be done when grill is cool and with the fuel supply disconnected.
2. Do NOT clean any grill part in a self-cleaning oven. The extreme heat will damage the finish.
3. Do NOT enlarge valve orifices or burner ports when cleaning the valves or burners.
W CAUTION: Unplug rotisserie motor from the outlet when not in use and before cleaning. Allow to cool before
putting on or taking off parts.
Notices
1. This grill should be thoroughly cleaned and inspected on a regular basis.
2. Abrasive cleaners will damage this product.
3. Never use oven cleaner to clean any part of grill.
Before Each Use:
1 . Keep the grill area clean and free from any combustible materials, gasoline, and other flammable vapors and liquids .
2 . Do NOT obstruct the flow of the combustion of LP gas and the ventilation of air .
3 . Keep the ventilation opening(s) of the LP gas tank area free and clear from debris .
4 . Visually check the burner flames to make sure your grill is working properly (Figure 10) .
5 . See below for proper cleaning instructions .
6 . Check for obstructions of airflow to the burners . Spiders, insects and webs can clog the burner/venturi tube . A clogged burner tube can
lead to a fire .
Cleaning Surfaces
1 . Wipe surfaces clean with mild dishwashing detergent or baking soda mixed with water .
2 . For stubborn surfaces, use a citrus-based degreaser and a nylon scrubbing brush .
3 . Rinse clean with water .
4 . Allow to air dry .
Cleaning Main Burners
1. LP: Turn LP gas tank valve to "CLOSED ."
NG: Turn natural gas main valve to "OFF ."
2 . Turn all control knobs clockwise to the " OFF" position .
Note: A "poof" sound is normal as the last of the gas is burned .
3. LP: Disconnect LP gas tank per "Disconnecting LP Gas Tank" section .
NG: Disconnect main gas line per "Disconnecting Natural Gas Line" section .
4 . Remove cooking grids and heat plates .
5 . Remove burners by removing the fasteners, which secure the burners to the grill bottom .
6 . Lift burners up and away from gas valve orifice .
7 . Disconnect wire from spark electrode .
8 . Clean venturi of each burner with small bottle brush or compressed air .
9 . Remove all food residue and dirt on burner surfaces .
10 . Clean any clogged ports with a stiff wire (such as an opened paper clip) .
11 . Inspect burners for any damage (cracks or holes) . If damage is found, replace with new burner(s)
from manufacturer .
12 . Reinstall burners, checking to insure that gas valve orifice is correctly positioned inside each
burner venturi . Also, check position of spark electrode .
13 . Replace heat plate(s) and cooking grid(s) .
14. LP: Connect LP gas tank per "Installing LP Gas Tank" section .
NG: Connect NG main line per "Installing Natural Gas Line" section .
15 . Perform leak test per "Checking for Leaks" section .

Cleaning and Care

Figure 10
Burner Flame Conditions
Use this chart to see if your burners
need to be cleaned .
1-2 in. /
25.4 - 50.8 mm
Normal: Soft blue flames with yellow
tips between 1 in . - 2 in . height .
Needs cleaning: Noisy with hard
blue flames .
Has to be replaced: Wavy with
yellow flames .